Overview

Zinsser Peel Stop is a clear sealer for use on interior and exterior surfaces where peeling, flaking, dusting, or chalking is a problem. This flexible finish, forms a breathable membrane over faulty or difficult substrates, creating a sound surface for new paint. Its formulated to allow moisture to escape the surface therefore stopping peeling problems on old or new surfaces.

• Flexible and breathable

• Quick drying

• Can be applied on cracked or crazed surfaces

• Can be top coated with a water-based or alkyd paint

Preparation

Always ensure the surface to be treated is clean, dry and free from any dust, grease, oil, wax, mould or possible contaminates that may interfere with adhesion.

• Thorough surface preparation is highly recommended

• Wash the surface with an appropriate cleaning solution or solvent

• Surface must be free from any loose material, old paint ca be sanded or scraped

• Lightly sand exposed wood to remove loose fragments

• Sand all glossy surfaces with sandpaper

Application

Before applying stir the product thoroughly and test a small area

• Shake or stir well before use

• Do not thin, Zinsser Peel Stop is ready to use

• Application can be done with a synthetic brush, roller or airless sprayer

• Only apply in temperatures between 10-32°C

• To seal cracks and edges of old paint, back brush or roll

• Allow to dry for 2 hours, Peel Stop should dry to a slight sheen

• Apply a second coat if dull spots appear

• If conditions do not permit prompt drying, allow Peel Stop to dry overnight before priming or painting

Note: Any water-based or alkyd primer or paint may be used over Peel Stop. As Peel Stop is clear, we recommend priming with Zinsser Bulls Eye 1-2-3 or Zinsser Cover Stain, followed by a coat of quality water-based or alkyd paint to assure optimum results.

Note: Always follow the manufacturer instructions found on the tin.