Overview

Sikkens Rubbol XD Gloss is an exceptionally durable, solvent based, high gloss finish for interior and exterior joinery and suitable primed metals and hard plastics. The most durable finish from Sikkens with a maintenance cycle of 8 – 10 years. Can be used as part of a system with Sikkens Rubbol Primer Plus.

• One coat maintenance

• Advanced performance with outstanding gloss retention

• Extremely durable

Note: Rubbol XD Gloss is not recommended for use indoors as its drying times may be extended

Preparation

Always ensure the surface to be treated is clean, dry and free from any dust, algae, fungi or moss.

• Resinous deposits should be removed with a scraper

• Degrease the surface with a lint free cloth and suitable solvent, allow to evaporate fully before applying Sikkens

• For previously painted or worn wood use a fine sandpaper of 240 grit work in the direction of to abrade the surface the grain remove any loose paint

• Dust down entire surface

• Fill any cracks, holes or chips, always use a filler designed for timber

Application

Before applying stir the product thoroughly and test a small area to ensure you are happy with colour and adhesion. Colours can vary dependent on surface to be treated.

• Do not apply when there is the risk of rain or when temperatures are below 8°C or above 30°C

• Protect from frost and rain until dry

• Always ensure product is fully mixed before and during application to ensure consistency in colour and sheen

• Do not thin, excessive thinning will reduce opacity

• For best results use a good quality, soft bristle brush

• The product should be applied in a full flowing coat, laying off in the direction of the grain, using the minimum number of brushstrokes necessary to produce an acceptable finish

• Avoid over brushing

• Apply 2 coats

• Allow 24 hours drying time between coats

• If the second coat is not applied within 48 hours, light sanding with a medium grade abrasive, to provide a surface “key” will be required. Ensure all dust is removed

• Subsequent coats should be applied within 48 hours in order to provide full protection

• Carefully denib the first coat using a fine grade nylon abrasive pad or a fine grade (P240 or finer) wet or dry silicon carbide abrasive paper. Remove all dust.

• Subsequent coatings should be applied as soon as possible after Cetol BL Primer has dried, but no sooner than 15 hours, in order to provide full protection and isolation of extractives

• On new wood were possible the first coat should be applied all round prior to fixing

• Pay special attention to areas of exposed grain e.g tops and bottoms of doors

Note: Always follow the manufacturer instructions found on the tin.

Aftercare & Storage