Overview

Sikkens Rubbol Satura Plus is a solvent based, satin finish for exterior and interiors joinery and suitably primed metals and hard plastics. It’s a durable paint with excellent opacity giving even coverage and protection on joinery for up to 5 years. A flexible formula that resists peeling and flaking. Can be used as a two part system with Sikkens Rubbol Primer.

Preparation

Always ensure the surface to be treated is clean, dry and free from any dust, algae, fungi or moss.

• Resinous deposits should be removed with a scraper

• Degrease the surface with a lint free cloth and suitable solvent, allow to evaporate fully before applying Sikkens

• For previously painted or worn wood use a fine sandpaper of 240 grit work in the direction of to abrade the surface the grain remove any loose paint

• Dust down entire surface

• Fill any cracks, holes or chips, always use a filler designed for timber

Application

Before applying stir the product thoroughly and test a small area to ensure colour and adhesion. Colours can vary dependant on surface to be treated.

• Do not apply when there is the risk of rain or when temperatures are below 5°C or above 30°C

• Protect from frost and rain until dry

• Always ensure product is fully mixed before and during application to ensure consistency in colour and sheen

• Do not thin

• For best results use a good quality, long-haired, soft bristle brush

• The product should be applied in a full flowing coat, laying off in the direction of the grain, using the minimum number of brushstrokes necessary to produce an acceptable finish

• Avoid over brushing

• Apply 2 coats

• Allow 18 hours drying time between coats

• Second coat must be applied within 48 hours to provide full protection, if not applied within 48 hours light sanding with a medium grade abrasive, to provide a surface “key” will be required, ensure all dust is removed

• On new wood were possible the first coat should be applied all round prior to fixing

• Pay special attention to areas of exposed grain, tops and bottoms of doors and undersides of cills

Note: Always follow the manufacturer instructions found on the tin.

Aftercare & Storage