Overview

Please note: The 1.78L Base Colour (Goosewing or Tideway) + 3.22L Activator must be purchased as a 2 part system. Both can be selected from the colour dropdown.

Highly durable and suitable for heavy commercial use and high traffic areas, Dulux Trade High Performance Floor Paint is a water-based two-pack epoxy system. Its hard wearing properties make it suitable for both interior and exterior areas. It offers excellent abrasion resistance on concrete and metal floors, due to its highly durable mid-sheen finish.

Do not use on power float/case hardened concrete or where silicate hardeners have been used, Terrazzo and Granolithic or substrates that have not fully dried out or do not incorporate an effective damp-proof membrane.

Preparation

For best results, ensure surfaces to be painted are sound, clean and dry. New surfaces particularly must be fully dry and free from all defective or poorly adhering material such as dirt, grease or wax.

Use a suitable oil and grease remover to clean the surface if necessary. New surfaces must be brushed with a stiff brush to remove all loose surface material. Porous surfaces must be sealed with a thinned first coat.

Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.

Application

Always follow the manufacturer's directions found on the tin

Do not use on power float/case hardened concrete or where silicate hardeners have been used, Terrazzo and Granolithic or substrates that have not fully dried out or do not incorporate an effective damp-proof membrane.

Apply with a brush or roller only, do not spray.

Mixing Ratio: Supplied in correct proportions. Add all of the Base to the Activator container and mix thoroughly for at least 5 minutes using a jiffy paddle in an electric drill, until the product is smooth and even. Do not mix part units. Badly activated or incorrectly mixed materials will affect performance and may cause early failure or discolouration. The mixed product should be allowed to stand for 5 minutes before application commences. Once started, application should continue without a break, cutting in where necessary as the application proceeds.

Pot Life: Up to 1 hour at 15°C. Up to 45 minutes at 23°C. Poor adhesion will result if product is thinned and used after pot life times. Coverage: Up to 6m2 per litre.

Aftercare & Storage