Overview

Ideal for use on wooden floors and other interior wooden areas where there is high wear and tear, Dulux Trade Diamond Glaze is a highly durable water based interior clear wood varnish, available in a gloss or satin finish. A simple one pack system, it is up to ten times tougher than conventional wood varnishes and is resistant to common chemicals, alcohol and water. Suitable for use over materials such as cork tiles, hardwood and chipboards.

Preparation

Make sure surfaces to be varnished are sound, clean and dry. Special precautions should be taken during surface preparation of pre-1960s paint surfaces over wood and metal as they may contain harmful lead.

General: All traces of grease, wax and polish must be completely removed. See Dulux Trade Diamond Glaze Varnish leaflets for further info. Not suitable for use on laminated floors.

New or bare wood: Sand the surface in the direction of the grain to remove any imperfections etc. and remove residues with a damp lint free cloth. Do not inhale dust. Wear a suitable face mask if dry sanding. Seal all new or bare wood by applying one coat of Clear Gloss Diamond Glaze Varnish to help reduce absorbency variations, which can cause differences in colour and sheen. Wood dyes may be used prior to applying Diamond Glaze Varnish. It is recommended that a water- based dye be used.

Coated surfaces in good condition: Sand back to provide a good surface key and to give a uniform appearance. Do not use wood dyes or stains over previous coatings as the adhesion will be poor.

Coated surfaces in poor condition: Where the existing coating is defective it must be completely removed and the surface prepared as described for new or bare wood above.

Making good: Make good where necessary using a suitable tinted stopper.

Floor Sanding: For even appearance, prepare the floor by using an industrial drum sander and edge sander, available from a local hire shop. Always sand in the direction of the grain. A belt sander or orbital sander can be used for smaller areas. Remove all dust from floor and surrounding areas using suitable vacuum equipment.

Application

Note: always follow the manufacturer's instructions found on the tin

Do not apply Dulux Trade Diamond Glaze in temperatures of 10 degrees celsius or lower or in areas of high humidity or condensation. Do not place very hot objects such as coffee pots, bottles etc. directly on top of Diamond Glaze Varnish. Surfaces should be protected from water, steam, spillages and hard stress, for example abrasion or polishing, for a minimum of 5 days after application. With careful occupation, light foot traffic is allowed after 24 hours but to prevent possible damage to floor while the full mechanical resistance develops, avoid heavy wear and do not replace carpet or rugs or move furniture for at least 7 days after application. Stir thoroughly before you begin. Apply with a brush or short pile mohair roller only. Do not spray.

Stir thoroughly before you begin, taking care not to use a whipping motion, which will introduce air and cause foaming when applied. Apply 2 or 3 coats evenly and consistently, taking care to keep the 'wet edge' alive and finish off along the grain. Apply a small test area first to check adhesion and appearance. If you are applying a second coat, allow at least 2 hours between coats. Rub down lightly along the grain between coats using a fine grade adhesive paper. Before using coloured Diamond Glaze Varnish on base wood, pre-seal with a coat of Diamond Glaze Varnish Clear Gloss to minimise colour absorption differences.

Aftercare & Storage