Overview

Peelaway Marine is ideal for the removal of anti-fouling, paints and varnishes on most hull types including GRP, wood, steel and concrete. It's patented water-based formula effectively strips multiple layers of anti-foul in just one application reducing the need for repeated scraping. The easy application and removal ensures there are no airbourne toxic particles released and waste can be easily collected to reduce boatyard contaminations. It is also less aggressive on the hull compared to blasting which can reveal Osmotic blisters. The light paste consistency and is easy to apply to vertical surfaces and difficult shapes

• No airbourne toxic particles

• Waste can be easily removed

• Non corrosive formula

Always carry out a test patch before general application

Preparation

Ensure the area to be treated is clean and free from dust, debris, and other contaminants to ensure good adhesion.

• Remove any build of fouling or blistered old anti-fouling coat

• Cover any surrounding surfaces with a polythene sheet and masking tape

• Always wear suitable protective clothing

Always apply a test patch before using this product, test patches should be completed before undertaking any paint removal project.

• Mask off a small area and apply the paste at different thicknesses its recommended to do test strips at 1mm, 2mm, and 3mm

• Allow to stand from 2 to 48 hours, leave longer for heavy build up over moldings (up to 72 hours)

• To remove, the spatula should be inserted into the paste and a section gently lifted away. If the original surface is apparent, the test patch can be removed and the surface wiped with a damp sponge. If the paint can still be seen, the test patch should be replaced and re-examined after a few hours.

• Continue testing until the original surface is no longer apparent to establish correct paste thickness, timing, and the designated paste to be applied

Application

Before applying the product test a small area on the surface to be treated to ensure you are happy with your results. It is essential that a test area be completed on the surface to be stripped to help ensure that the results will be satisfactory.

Flat Surfaces

Dwell time as indicated by the test patch this can be between 30 minutes and 48 hours, do not use for longer than 48 hours

Removal