Overview

Sikkens Cetol THB Plus is a solvent borne, semi-gloss finishing coat with a medium build. It can be used as part of a system on bare wood with Sikkens Cetol HLS Plus as a base coat. It’s highly translucent and will colour whilst allowing the beauty of the woodgrain to be seen.

• Easy to apply

• Flexible, water repellent coating

• Prevents cracking, flaking or peeling

• Good for areas where regular maintenance is acceptable

Preparation

Always ensure the surface to be treated is clean, dry and free from any dust, algae, fungi or moss.

• Resinous deposits should be removed with a scraper

• Degrease the surface with a lint free cloth and suitable solvent, allow to evaporate fully before applying Sikkens

• For previously stained or worn wood use a fine sandpaper of 240 grit work in the direction of to abrade the surface the grain

• Dust down entire surface

• Fill any cracks, holes or chips, always use a filler designed for timber

Application

Before applying stir the product thoroughly and test a small area to ensure colour and adhesion. Colours can vary dependant on surface to be treated.

• Do not apply when there is the risk of rain or when temperatures are below 5°C or above 30°C

• Protect from frost and rain until dry

• Always ensure product is fully mixed before and during application to ensure consistency in colour

• Do not thin

• For application use a good quality, long-haired, soft bristle brush

• Apply along the grain in even strokes and avoid over brushing

• Apply to a minimum wet film thickness of 60 micrometres

• Pay special attention to areas of exposed grain, tops and bottoms of doors and undersides of cills

• Allow a minimum of 16 hours drying time

• The second coat should be applied to all exposed surfaces, as soon as possible after the first coat has dried, but no sooner than 16 hours

• Additional preparation may be required if over 3 months between coats

Note: Always follow the manufacturer instructions found on the tin.

Aftercare & Storage